The easy
installation of the Rose+Krieger hidden bracket is
illustrated. Version 1 uses one long Steel T-nut connector.
Version 2 uses two T-nut Spring clips.
|
|
1. |
Screw in steel
plug about 20mm below end of beam with an Allen wrench.
Cutting oil and/or drill with attachments speeds this
process (pneumatics recommended). |
|
2. |
Secure the
hidden bracket to the steel plug with the supplied screw.
Use an Allen wrench to do this. The square flange on the
hidden bracket is self-centering square flange on the hidden
bracket is self-centering and seats perfectly in the end of
the beam. |
|
3. |
Drop the Version
2 Spring Clip type t-nuts into the t-slots and move to
desired position. If you are using the Version 1 type Hidden
Bracket connector, move the single steel t-nut connector to
the desired position with the supplied set screw, using an
Allen wrench. |
|
4. |
Put beams
together and bolt hidden bracket to the t-slot spring
clips/or steel t-nut connector with supplied screws and
washers. |
